I hate the clock changes. Yes, I know most do it themselves but I have four that requir manual change. My Oven, is only 18 month old, (So Ihave changed it alrady twice). Got out the manual, did not help at all, shouted at it, still stayed same time, went to u-tube, did not have my model. By now Ihad spent over half an hour on this machine. Decided to leave it at smmer time for next five months, poked finger at button to tell it and it all flashed and permitted me to change it. Now have to worry about changing it back next March,
Mirowave changed easily following manufactuers instructions, then to my lovely, westminster Chimes Wooden Wall clock in Living Room. This can ONLY be changed from the rear, so has to come down off the wall. Sadly, where I have been hanging it for the past four years, the plaster is poor and I have had increasing problems to find a hook that will stay on the wall for this clock to hang on.
Kept it down long enough to ensure that the chimes will still correct (actually had to wind it forward 23 hours to do this, using kitchen steps climbed up and hung it back on hook, down steps, just as it crashed down, knocking a picture frame off that wall, (this crashed down to the floor with glass everywhere, fortunately I managed to half save the clock and that was not damaged.
Have now put this clock onto a different wall, repaired the hook damage to that wall, and purchased a new picture frame/ I hate clock changes!!!!!!