Ironing board cover - Sewing

Susie42

I sent two old ironing boards to a local charity who were collecting equipment for an African charity. Don’t send to landfill as they still can be used.

If it comes to that & I hope not. Then that is an idea. Thank you

midgey

Long time ago ironing board covers were an unknown thing! Have you an old blanket or sheet that you can use?

I guess that would be fine when ironing things flat. I tend to use the tapered end of the board a lot.

eddiecat78

Look at ironingboardcovers.co.uk. Sadly they no longer make made to measure covers but do still have large sizes. I've had 2 from them and they are very good quality

Thank you eddiecat78. I have looked everywhere. As I said it's the design of the board

Stansgran

Sorry,slow typist,Welshy beat me to it.

I can't sew unfortunately

Long time ago ironing board covers were an unknown thing! Have you an old blanket or sheet that you can use?

Look at ironingboardcovers.co.uk. Sadly they no longer make made to measure covers but do still have large sizes. I've had 2 from them and they are very good quality

I sent two old ironing boards to a local charity who were collecting equipment for an African charity. Don’t send to landfill as they still can be used.

Sorry,slow typist,Welshy beat me to it.

Can you not unpick the worn one and take a pattern from it? I have a Brabantia and can never remember the size when I bought a new cover ,they all look the same,so bought the largest and cut to shape.

Also when I asked about the covers on Amazon, one lady replied with this. But you can't reply back to her direct

You are absolutely right, I haven’t managed to find a cover that fits either! As I am a dressmaker I have been lucky to make a cover. I bought an extra large new cover, ironed the old cover flat then used it as a pattern to recut a new cover from a new ironing board cover I bought. I stitched a deep bias binding all the way round the edge and threaded some elastic through and pilled it up. It is perfect. It was the only way I could solve the problem. It is a brilliant ironing board cover, but to not make replacement new covers is madness. I hope this helps in some way.

Someones review on Amazon ............ Great ironing board, really sturdy, would highly recommend it for ironing, BUT and it's a big but you'll notice, both times we've needed to replace the cover, finding a compatible cover is nigh on impossible. Try it, google Keter 45 ironing board cover and everywhere that should stock them, is out of stock, always. With hindsight would have bought a generic sturdy one where the covers from anywhere fit. Problem is the lip at the bottom edge, needs a special type of design.